It’s proven that all golfers ideally like to hit a drive off the tee and through the treetops towards the targeted hole. It’s better to perform long drive together with some company, nonetheless long drives don’t make a sense if you can’t even sink a putt. The short shot with an iron is as crucial, if not more essential, than the long shots with a wood. This kind of shot may seem simple but, to the inexperienced golfer, it can be the most difficult shots to play. This article will provide some good info regarding how to hit irons efficiently when playing golf.
Step #1: Alignment of the Body and Right Posture
The right set up of the body such as proper posture and alignment is the first step to an effective hit. The most typical mistake created by many newbie golf players is bending of the body. An inexperienced golfer will bend from the back over the club instead of at the waist. This will certainly affect the trajectory negatively and will result in a great muscle pain in the back. When golfing keep the back straight, but not firm. Tilt your body by the waist and allow a swing through your hips. It is important that you maintain an even position over your feet to ensure that you remain balanced throughout the swing.
Step #2: Ball Position
In setting up iron shot, ball positioning is the most overlooked aspect. Long drives is the most considered position by a lot of golfers but short shot is also essential. When we discuss the ball placement, we refer to the position in accordance with your body. The right ball and body position is with the ball not farther back on the sternum and not farther beyond your left armpit. Newbies go wrong by playing the shot too far forward that causes to poor slices and putts. Try to hit the ball again and this time with your sternum straightened, if the ball heads into the ground when hit.
Step #3: Executing a Takeaway Position
The way wherein the club is pulled back and hit through is named takeaway position. The style of the takeaway is essential as it contributes considerably to the type of swing which will be enjoyed and its success. The technique used when hitting with an iron is the 2-8-2 rule. The first “2” defines the first 2 inches of a takeaway wherein the club goes straight back. It is a must to move the body (arm, legs and shoulders) in sync. The “8” refers to the eight inches when in the club curves in an upward direction but without moving the wrists. Last but not least, at the twelfth inch, the wrist turns placing the shaft horizontal to the ground. The hands should level to the shoulder height and the shoulder must be tight. Follow through along the target line and then hit the ball with a square iron face, accomplish this after forming the takeaway.
Step #4: Take Consideration of the Course
Obviously, while the set up and follow through of the swing are both vitally important, it is also important to consider the layout. Any adjustments while executing a swing or even takeaway, will be because of the surface of the ground where it’s being executed. If the ball is to be played on a downhill slope, it’s always best to complete a downswing at the point where the ball will fall towards the hole. For instance, a green with a slight downhill would be best performed at a slight curve to allow for gravitational pull. It’s always best to remove any obstructions to have a greater shot.
The post Guide For Beginners Concerning How To Hit Irons In Golf appeared first on Fairfield Golf.
from Fairfield Golf http://ift.tt/2clk7sW
Main Site: scratchgolfacademy.com
Youtube Channel: Scratch Golf
from WordPress http://ift.tt/2clyCgf
No comments:
Post a Comment